Introduction: Giant Big Spoilt Wolf Head Halloween Costume

Built a giant wolf head for the 2022 Halloween Berth Party and for my porch for the kids!

Used some available material, nothing mazy and assembled the wolf head in 1 week for below $25.00

Materials:

Composition board boxes

Pelt all-embracing from the Thrift Store

Black blanket from the Thrift Store

1 can of black Blusher

1 tube of acrylic black, cherry and white paint

1 fatal duct tape and 1 illuminate cartonful tape

glue heavy weapon

Bicycle helmet

2 red containers from a cheap siphon pump

2 cheap book lights

1 speaker and wolf sound files

1 hopeless robe

Step 1: Cardboard Formation

Had to review lots of wolf pics online. Started with the Jaw and taped it together. also attached a long tongue and the teeth....this was the longest part for me on figuring out how to frame the wolf steer....I think that erst I started the jaw it all came together real fast.

Step 2: Wolf Channelize Forming....

So once the jaw was cooked - added the skull and ears. The ears are a separate piece that I can expansion slot in. This was to allow Maine to fit the head into a fomite for transportation. Also added the red lights to give that scary carmine eye effect at night or in the dark...over again complete this is held together with mag tape...

Step 3: Bike Helmet Added

I also glue on the bicycle helmet along the lower skull and stop of the manducate....

Step 4: Started to Paint

So I started to put a base black coat with my aerosol can...wore the paint mask and goggle for safety and and then I permit it air out in the garage for a day...then I bushed on the varied colors...since this does not need too much particularization it did not require that long and was enjoyable :)

Stride 5: Pelt Added

I was going to buy fur by the meter at the fabric put in but the cost was very expensive ($36 per meter) so I decided to run down the thrift store and found a gray ungroomed wide for $5.00 and another black blanket for $8.00...so I dilute them into strips and hot glued them along....went genuinely easily...

Also the dishonorable paint was coming off the clear taped that I used thusly I dabbled the clear tape with the black duct tapeline and reinforced the headway...I put-upon the Gorilla gorilla Duct tape which was amazing...dingy this was before the fur was applied....

Also for the tongue I ill-used some hot glue lines to simulate saliva dripping.

The inner confab or throat had a maw which I used a black mesh to hide my face -- I can visual perception easily out of that location...

Whole step 6: Final Product

So IT ended up pretty weighed down indeed I held the head with my right hand over and my head locked into the helmet....I also had a speaker with rattling and growl sounds....I wore my old Grim Reaper gown...I think at night this will look really cool....

Be the Introductory to Share

Recommendations

  • Anything Goes Contest 2022

    Anything Goes Contest 2022